Allied Telesis AT-2450 Series Installation Manual page 27

8. From the Main Menu of the diagnostics program, select one of the
following:
DIAGNOSTICS for the simple test (no loopback)
LOOPB. WRAP PLUG for the loopback test
The various components will now be tested. This will take between
one and two minutes. If the test was successful, a window similar to
Figure 6 will be displayed.
Figure 6 Diagnostic Window (1 of 5)
You can follow the progress of the test in the right-hand window.
Each test is displayed as it is being performed (e.g. Board Register
Check).
If the test is successful, the word PASSED is displayed at the end of
the line and the next test is started. If there is a problem, the word
Failed is displayed.
If errors are reported, follow the instructions that are provided.
9. Check the configuration and if necessary, repeat the test (see Failure
of a Test).
10. To continue testing, press any key.
11. To quit the diagnostics program, select Exit from the Main Menu.
Network Adapter Card Installation Guide - Book II
27