Reading Configuration Data - Allied Telesis AT-2450 Series Installation Manual

Diagnostics
Reading
Configuration
Data
34
3. You can close the window by selecting Hide Sensors from the Main
Menu.
Other windows may be opened while this window is still open, for
example, the window displaying the configuration data.
To read configuration data, perform the following procedure:
1. Start the main program. Refer to
instructions.
2. Select SHOW CONFIGURATION in the main menu. A separate
window will be displayed showing:
Device code (Device)
Various vendor codes (Vendor)
Interrupt no. (IRQ)
Cache Line Size (CLS)
Latency (Lat.)
RAM size (RAM)
PCI slot index and size (Slot and Slot size)
PCI bus clock (clk)
MAC address (MAC Addr)
Port type (PMD-Type)
Connector (connector)
Hardware revision (HW Rev)
Chip ID (Chip Id)
In the Main Menu, Show Configuration changes to Hide
Configuration.
3. You can close the window by selecting Hide Configuration from
the Main Menu.
Other windows may be displayed while this window is still open,for
example, a window shown in Figure 9 will be displayed.
Main Program on page 32 for