For The At-2970 And At-2971 Series - Allied Telesis AT-2450 Series Installation Manual

For the AT-2970
and AT-2971
Series
To run diagnostics, perform the following procedure:
Note
Diagnostics is a DOS based program and must be run in true DOS,
not in a DOS shell within Windows.
1. If ON, power OFF your computer and reboot into DOS mode.
2. At the DOS prompt and without the drivers loaded, type diag.exe.
The location of the diagnostic files on the CardAssistant CD are:
Adapter Card
AT-2400 Series
AT-2500, AT-2501 Series
AT-2450, AT-2700,
AT-2701, AT-2745,
AT-2746 Series
AT-2915, AT-2930 Series
For example, if you want to run diagnostics for an AT-2500 Series
adapater card and the CD is mapped to drive D, you would enter:
D:\drivers\at2500\diag\diag25.exe
If you are using a driver installation disk, the diagnostic files are
stored in the root directory on the disk.
Diagnostics Program
The network adapter can be tested with the supplied diagnostics
program (running DOS). The diagnostics program run offline, for
example, normal operation of the network adapter can not be
maintained. During testing the link of the tested port will be down, for
examle, no data can be transferred. The following test are available:
Simple test without loopback
This test covers all components but not the port (socket including
components for transmitting/receiving the data signals).
Comprehensive port test with loopback
All componentes are tested, including the port.
Network Adapter Card Installation Guide - Book II
Diagnostic Location
\drivers\at2400\diag\diag24.exe
\drivers\at2500\diag\diag25.exe
\drivers\at2701\diag\diag.exe
\drivers\at29xx\diag\diag29.exe
25