Module Parameters - Allied Telesis AT-2450 Series Installation Manual

Module
Optional parameters for the driver can be supplied as command line
Parameters
arguments to the insmod command. Typically, these parameters are set
in the file /etc/modules.conf (see the man page for modules.conf). These
parameters take the form:
where the multiple values for the same parameter are for multiple NICs
installed in the system.
All the parameters are listed below.
<parameter>=value[,value,...]
Note
The default values will be used when invalid values are selected.
line_speed
Selects the line speed of the link. This parameter is used together
with full_duplex to select the speed and duplexity of the link.
The valid values are:
0
10
100
1000
Note
The 1000 Mbps must be negotiated for copper twisted pair links.
full_duplex
Selects the duplexity of the link. This paramter is used together
with line_speed to select the speed and duplexity of the link. Note
that this parameter is ignored if line_speed is 0.
The valid values are:
0
1
Network Adapter Card Installation Guide - Book II
Autonegotiate (default)
10 Mbps
100 Mbps
1000 Mbps
half duplex
full duplex (default)
65