Sabo 52-S A Operator's Manual page 69

Engine performance decreases
Pos : 15.3.4 /Innenteil/Stör ungs ursac hen und deren Besei tigung/Störungst abellenel emente/M otor läuft unr egel mäßig @ 0\mod_1127909273145_1521.doc @ 1891
Engine runs irregularly
Pos : 15.3.5 /Innenteil/Stör ungs ursac hen und deren Besei tigung/Störungst abellenel emente/M äher fährt nic ht @ 0\mod_1115376736218_1521.doc @ 1889
Mower will not move forward
Pos : 15.3.6 /Innenteil/Stör ungs ursac hen und deren Besei tigung/Störungst abellenel emente/Star ke Ersc hütterungen ( Vibrier en) @ 0\mod_1115377318234_1521.doc @ 1900
Extreme vibration
Pos : 15.3.7 /Innenteil/Stör ungs ursac hen und deren Besei tigung/Störungst abellenel emente/Sc hnitt unsa uber, R as en wird g elb, Benzin MUST ER @ 17\mod_1331728299135_1521.doc @ 134627
Cut not clean,
lawn turns yellow
Pos : 15.3.8 /Innenteil/Stör ungs ursac hen und deren Besei tigung/Störungst abellenel emente/Aus wurf verstopft, Benzi n, Seitenaus wurf, mit Antrieb MUSTER @ 23\mod_1362058094144_1521.doc @ 170270
Ejector blocked
Pos : 15.3.9 /Innenteil/Stör ungs ursac hen und deren Besei tigung/Störungst abellenel emente/Gemulc hte Gr as si eht s chl ech t aus Seitenaus wurf MUSTER @ 5\mod_1183466802540_1521.doc @ 35937
Mulched grass appearance is
poor:
clumps, excessive clippings,
rough cut.
Pos : 15.4 /Innenteil/Stör ungs ursac hen und deren Besei tigung/Störungsurs ac hen und deren Bes eitigung T ext Benzi n @ 0\mod_1115378183390_1521.doc @ 1905
In case of faults and defects which have not been listed here, please contact the nearest authorized dealer.
Repairs which require specialized knowledge should only be performed by a qualified expert. Your authorized dealer will
naturally also be glad to help if you do not wish to perform the maintenance work described here yourself.
===== Ende der Stüc kliste =====
Air filter dirty.
Spark plug contaminated with soot.
Air filter dirty.
Spark plug contaminated with soot.
Drive control bracket not pulled.
Cutting blade blunt.
Cutting height too low.
Motor speed too low.
Mowing speed too high.
Insufficient overlap between mowing
lanes.
Lawn matted.
Motor speed too low.
Cutting height too low with grass too
high.
Mowing speed too fast.
Grass is damp.
Blade blunt.
Mulching rule not followed (cut max.
1/3 of the grass height; the height of
the grass to be cut must be lower
than 10 cm)
Grass build-up under deck.
Driving speed too high.
Insufficient overlapping of cuts when
mowing.
Grass not dry.
17
Clean or replace air filter insert W .
Have it cleaned by an authorized dealer.
Clean or replace air filter insert W .
Have it cleaned by an authorized dealer.
Have it checked by an authorized dealer.
Pull drive switch bar G .
Have it checked by an authorized dealer.
Have it checked by an authorized dealer
Have it sharpened and balanced by an
authorised workshop Q .
Set higher cutting height I .
Work at max. speed.
Adapt mowing speed, switch motor drive off
if necessary.
If grass is long, the mowing lanes may need
to overlap further.
A perceptible improvement can be achieved
by using a scarifier.
Work at max. speed.
Set higher cutting height I .
Adapt mowing speed, switch motor drive off
if necessary.
Allow the lawn to dry.
Have it sharpened and balanced by an
authorized dealer.
Adjust to higher cutting height I .
Convert mower to side discharge R3 and
mow grass first with higher cutting setting.
Adjust to higher cutting height I .
Adapt driving speed, switch motor drive off
if necessary.
Tall grass conditions may dictate that more
overlapping of cuts is required
Adjust to higher cutting height I .
Let grass dry.
GB