Converting The Machine To Side Ejection (Illustration R3 ); Service Intervals - Sabo 52-S A Operator's Manual

Converting the machine to side ejection (Illustration R3 )

Pos : 11.22 /Innenteil/M ähbetrieb/U mbau als Seitenaus wurfmäher T ext @ 13\mod_1280318421567_1521.doc @ 110379
– Stop the engine and remove the spark plug.
– Remove the cover plate (1) from the right-hand side of the housing.
To do this loosen the two self-locking nuts (2) and pull the washers (3) off, pull the two flat round screws (4) out from the
inside (cutting space) and remove the cover plate.
The mulching blade system does not have to be converted!
For the equipment to be used as a mulching machine again, the cover plate (1) must be replaced. To do this, insert the cover
plate into the housing from the inside in such a way that the two bore holes in the cover plate are aligned with the bore holes
in the housing. Insert the two flat round screws (4) into the bore holes from the inside (cutting space), put the washers (3) in
place and tighten using the two self-locking nuts (2).
WARNING
Never use the equipment with the deflector damaged or missing.
Always work with the deflector closed (folded downwards) even when the machine has been converted for
mulching.
Pos : 12.1 /---------- 1 Leerzeil e ---------- @ 0\mod_1114611787140_1521.doc @ 2070
Pos : 12.2 /Innenteil/Wartungsi nter vall e/1 WARTUN GSINTERVALLE @ 4\mod_1159190053844_1521.doc @ 20987

14 SERVICE INTERVALS

Pos : 12.3 /Innenteil/Wartungsi nter vall e/War tungsinter valle Wic htig @ 19\mod_1346242607856_1521.doc @ 148773
IMPORTANT
Avoid damage! Under extreme or unusual conditions, shorter servicing intervals than the ones specified below may
be necessary. If you establish any problems, please contact an authorised workshop.
Pos : 12.4 /Innenteil/Wartungsi nter vall e/War tungsinter valle T ext @ 19\mod_1346242427863_1521.doc @ 147976
Carry out routine servicing on the machine in line with the following servicing intervals.
Work must be carried out at the following servicing intervals in addition to the maintenance work listed in these operating
instructions.
Pos : 12.5 /Innenteil/Wartungsi nter vall e/Vor der erst en Inbetriebnahme Benzi ner @ 19\mod_1346243924408_1521.doc @ 149049
Before initial use
• Check the oil level Y1 .
• Check all screw connections for a tight fit.
• Check the cutting blade screw and have an authorised workshop tighten it if necessary.
• Check whether the safety control bar for the engine brake is working perfectly.
• Check that all protective devices have been attached properly and are not damaged.
Pos : 12.6 /Innenteil/Wartungsi nter vall e/Vor j edem Betrieb Benziner Seitenaus wurf @ 21\mod_1351075225220_1521.doc @ 161597
Before every operation
• Check the lawn area and remove any objects.
• Check the area of the boundary wires (if an auto mower is being used for lawn care).
Check the oil level Y1 .
•
• Check the condition and firm fit of the blade, if necessary have an authorised workshop tighten the blade screw.
• Check whether the safety control bar for the engine brake is working perfectly.
• Check that all protective devices have been attached properly and are not damaged.
Pos : 12.7 /Innenteil/Wartungsi nter vall e/Alle 10 Betriebss tunden Sei tenaus wurf @ 22\mod_1353325454469_1521.doc @ 165545
Every 10 operating hours
• Check all screw connections for a tight fit.
• Check the blade coupling regularly for wear and a tight fit.
Pos : 12.8 /Innenteil/Wartungsi nter vall e/N ach jedem Betrieb @ 19\mod_1346243106654_1521.doc @ 148981
After every operation
• Clean the mower.
• Check the blade for damage and wear.
Pos : 12.9 /Innenteil/Wartungsi nter vall e/Einfahrzeit – Nac h den erst en 5 Betri ebsst unden B&S @ 19\mod_1346244491464_1521.doc @ 149253
Running-in time – after the first 5 operating hours
• Change the engine oil Y1 .
Pos : 12.10 /Innenteil/Wartungsinter valle/Alle 25 Betriebsst unden oder alle drei M onate Luftfilter, Zündkerze r einigen @ 22\mod_1353577712696_1521.doc @ 166804
Every 25 operating hours or every three months
Clean the air filter paper insert W .
•
• Clean the spark plug and adjust electrode distance Y .
Pos : 12.11 /Innenteil/Wartungsinter valle/Alle 50 Betriebsst unden oder einmal pr o J ahr 54er Benziner @ 21\mod_1352883350775_1521.doc @ 164421
Every 50 operating hours or once a year
Change the engine oil Y1 .
•
• Lubricate or grease the wheel bearings.
Pos : 12.12 /Innenteil/Wartungsinter valle/Bei der J ahresi ns pektion Benzi ner, mit Antrieb @ 19\mod_1346244765719_1521.doc @ 149304
During annual servicing
• Have the air filter paper insert replaced W .
Have the spark plug replaced Y .
•
• Clean the gearbox and the area under the belt cover.
• Check the drive throttle cable and adjust it if necessary.
13
GB