Replacing Or Rotating The Front Squeegee Blade - Tennant 5680 Operator's Manual

REPLACING OR ROTATING THE FRONT
SQUEEGEE BLADE
1. Make sure the squeegee is raised off the
floor.
2. Turn the machine power off.
FOR SAFETY: Before leaving or
servicing machine, stop on level
surface, set parking brake, and turn off
machine.
3. Remove the squeegee from the machine.
See REMOVING THE SQUEEGEE
ASSEMBLY.
4. Remove the rear squeegee blade and
retainer. See REPLACING OR ROTATING
THE REAR SQUEEGEE BLADE.
5. Loosen the two remaining knobs on top of
the squeegee assembly.
6. Pull the retainer plate back and pull out the
front squeegee blade of the squeegee frame.
7. Insert the rotated or new squeegee blade in
the squeegee frame, lining up the slots in the
blade with the tabs on the retainer plate.
8. Push the retainer plate forward. Tighten the
two outside knobs on top of the squeegee
assembly.
9. Insert the rear squeegee blade and retainer.
Tighten the two rear blade retention knobs
until the ends of the front and rear squeegee
blades touch. Do not overtighten.
10. Install the squeegee assembly on the
squeegee pivot. See INSTALLING THE
SQUEEGEE ASSEMBLY.
11. Adjust the squeegee blade leveling and
deflection as stated in LEVELING THE
SQUEEGEE and ADJUSTING SQUEEGEE
BLADE DEFLECTION.
5680 330459 (6- -05)
Home Find... Go To..
MAINTENANCE
67