Scrub Brushes And Pads; Disk Brushes; Replacing The Disk Brushes Or Pads - Tennant 5680 Operator's Manual

Hide thumbs Also See for 5680:

Table of Contents

MAINTENANCE

SCRUB BRUSHES AND PADS

The scrub brushes should be checked daily for

wire or string tangled around the brush or drive

hub. The brushes should also be checked for any

damage and wear.

The disk brushes should be replaced if large

amounts of bristles are missing, or if the remaining

bristles' length is less than 10 mm.

Cleaning pads must be placed on pad drives

before they are ready to use. The cleaning pad is

held in place by a pad holder.

Cleaning pads need to be cleaned immediately

after using with soap and water. Do not wash the

pads with a pressure washer. Hang dry pads, or

lie flat to dry.

NOTE: Be sure to replace brushes and pads in

sets. Otherwise one brush or pad will be more

aggressive than the other.

1. Raise the scrub head.

2. Turn the machine power off.

FOR SAFETY: Before leaving or

servicing machine, stop on level

surface, set parking brake, and turn off

machine.

3. Open the access cover on either corner of

the scrub head.

Home

Find... Go To..

5680 330459 (9- -02)

Table of Contents