Cylindrical Brushes; Replacing The Cylindrical Brushes - Tennant 5680 Operator's Manual

Hide thumbs Also See for 5680:

Table of Contents

MAINTENANCE

CYLINDRICAL BRUSHES

Check the brush taper and rotate the brushes

from front-to-rear every 50 hours of operation, for

maximum brush life and best scrubbing

performance.

The cylinder brushes should be replaced if large

amounts of bristles are missing, or if the remaining

bristles' length is less than 10 mm

(0.38 in).

NOTE: Be sure to replace brushes in sets.

Otherwise one brush will be more aggressive than

the other.

1. Raise the scrub head.

2. Turn the machine power off and set the

parking brake if your machine has this

option.

FOR SAFETY: Before leaving or

servicing machine, stop on level

surface, and turn off machine.

3. Push down on the mounting spring and the

idler door, then pull out on the bottom of the

door. Push down on the spring until the door

releases from the scrub head. Pull the idle

plug off the brush.

4. Pull the brush out of the scrub head.

5. With the double row end of the brush

towards you, guide the brush onto the drive

hub.

NOTE: Use the double rows on the idler end of

the brush.

Home

Find... Go To..

5680 330459 (11- -05)

Table of Contents