Scrub Head; Disk Brush Scrub Head Skirt; Cylindrical Brush Scrub Head Skirts; Adjusting The Scrub Head Skirts - Tennant 5680 Operator's Manual

SCRUB HEAD

The machine is equipped with a disk brush scrub
head. The scrub head contains skirts to control
over-spray from the scrub brushes.

DISK BRUSH SCRUB HEAD SKIRT

Make sure the scrub head skirt touches the floor
all the way around when the scrub head is
lowered. Check the skirt for damage or wear daily.
NOTE: Replace the scrub head skirt when it is
damaged or no longer is able to touch the floor.

CYLINDRICAL BRUSH SCRUB HEAD SKIRTS

The four head skirts should just touch the floor.
Check the skirts for damage or wear daily.

ADJUSTING THE SCRUB HEAD SKIRTS

1. Lower the scrub head on a level floor.
2. Turn the machine power off.
FOR SAFETY: Before leaving or
servicing machine, stop on level
surface, and turn off machine.
3. Check to see if the scrub head skirts touch
the floor.
4. If any of the skirts needs adjusting, loosen
the retainer strip hardware and slide the skirt
to the proper adjustment. Tighten the
retainer strip hardware.

REPLACING THE SCRUB HEAD SKIRTS

1. Raise the scrub head.
2. Turn the machine power off.
FOR SAFETY: Before leaving or
servicing machine, stop on level
surface, and turn off machine.
3. Remove the retainer strip and hardware.
4. Replace the old skirt with a new skirt and
mount in place with the retainer strip and
hardware.
5680 330459 (11- -05)
Home Find... Go To..
MAINTENANCE
45