Separation Engine From Front Axle Frame - wsm Kubota L4100 Workshop Manual

L4100, WSM

(2) Separation Engine from Front Axle Frame

Clutch Assembly
1. Insert the clutch center tool.
2. Remove the clutch assembly together with the clutch center
tool.
(When reassembling)
• Direct the shorter end of the clutch disc boss toward the
flywheel.
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the splines of clutch disc boss.
• Insert the pressure plate, noting the position of straight pins.
IMPORTANT
• Be sure to align the center of disc and flywheel by inserting
the clutch tool set.
NOTE
• Do not allow grease and oil the clutch disc facing.
Tightening torque Clutch mounting screw
(1) Clutch Disc
Fuel Tank
1. Disconnect the fuel pipe (4) and drain the fuel.
2. Disconnect fuel return tubes (2).
3. Remove rear bonnet support mounting screws (3) on both
sides.
4. Remove fuel tank (1) together with rear bonnet support (6) and
shutter plate (5).
(1) Fuel Tank
(2) Fuel Return Tube
(3) Bonnet Support Mounting Screw
Radiator Hose, Recovery Tank, Muffler
1. Disconnect radiator hose (1), (3) and air cleaner hose (4).
2. Disconnect recovery tank hoses (5) and then remove recovery
tank (6), recovery tank stay (7).
3. Remove muffler (8).
(When reassembling)
Tightening torque Muffler mounting screw
(1) Radiator Hose
(2) Radiator Cap
(3) Radiator Hose
(4) Air Cleaner Hose
1-S24
ENGINE
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
(2) Pressure Plate Assembly
9Y1210278ENS0026US0
(4) Fuel Tube
(5) Shutter Plate
(6) Rear Bonnet Support
9Y1210278ENS0027US0
32 to 39 N·m
3.2 to 4.0 kgf·m
24 to 28 lbf·ft
(5) Recovery Tank Hose
(6) Recovery Tank
(7) Recovery Tank Stay
(8) Muffler
9Y1210278ENS0028US0
KiSC issued 08, 2012 A
(EU)