wsm Kubota L4100 Workshop Manual page 133

L4100, WSM
Shift Linkage
The PTO Clutch control lever (1) and the PTO clutch
valve (4) are connected by the shift cable (3) as shown
in the left figure.
When the shift lever is moved to the "B" side, the
PTO clutch valve (4) is set at "ENGAGED" position.
Then the oil flows to clutch pack through the PTO clutch
valve (4), and the clutch pack is engaged and the PTO
shaft rotates. When the shift lever is moved to the "A"
side, the PTO clutch valve (4) is set at the
"DISENGAGED" position.
(1) PTO Clutch Control Lever
(2) Lever Guide
Oil Flow
The oil adjusted the pressure by the regulator valve
flows into the PTO clutch valve (2). When the PTO lever
is at the "DISENGAGED" position, the oil does not flow
through the PTO clutch valve (2) to the PTO clutch pack
(3).
When the PTO lever is at the "ENGAGED" position,
the oil flows through the PTO clutch valve (2) to the
accumulator (4) and the PTO clutch pack (3) to engage
it.
(1) Check Valve
(2) PTO Clutch Valve
(3) PTO Clutch Pack
(4) Accumulator
2-M2
CLUTCH
(3) Shift Cable
(4) PTO Clutch Valve
9Y1210278CLM0006US0
A: From Regulator Valve
B: Pressure Check Port
9Y1210278CLM0004US0
(EU)
KiSC issued 08, 2012 A