Disassembling And Assembling; Traveling Clutch - wsm Kubota L4100 Workshop Manual

L4100, WSM

[3] DISASSEMBLING AND ASSEMBLING

(1) Traveling Clutch

PTO Clutch Valve
1. Disconnect the PTO shift cable (1) from the PTO clutch valve
(2).
2. Remove the PTO clutch valve assembly (2).
(When reassembling)
• Replace the hydraulic pipe (3) with new ones and apply oil to
them.
• Apply small amount of grease for the O-ring (4).
• When assembling the PTO clutch valve, adjust the PTO shift
cable (1). (Refer to "[1] CHECKING AND ADJUSTING" in this
section.)
PTO clutch valve mounting
Tightening torque
screw
(1) PTO Shift Cable
(2) PTO Clutch Valve
Clutch Assembly
1. Insert the clutch center tool.
2. Remove the clutch assembly together with the clutch center
tool.
(When reassembling)
• Direct the shorter end of the clutch disc boss toward the
flywheel.
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the splines of clutch disc boss.
• Insert the pressure plate, noting the position of straight pins.
IMPORTANT
• Be sure to align the center of disc and flywheel by inserting
the clutch tool set.
NOTE
• Do not allow grease and oil the clutch disc facing.
Clutch assembly mounting
Tightening torque
screw
(1) Clutch Disc
2-S15
CLUTCH
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
(3) Hydraulic Pipe
(4) O-ring
9Y1210278CLS0016US0
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
(2) Pressure Plate Assembly
9Y1210278CLS0017US0
KiSC issued 08, 2012 A
(EU)