wsm Kubota L4100 Workshop Manual page 337

L4100, WSM
Flasher Unit
1. Disconnect the connector from the flasher unit.
2. Turn the main switch at ON position.
3. Measure the voltage between the 12, 13 terminal and chassis.
4. If the voltage differ from the battery voltage, the wiring harness
is faulty
12 terminal – Chassis
Voltage
13 terminal – Chassis
(Reference)
1 0.85Y
2 0.85Y/R
3 0.5W/B
4 0.85R/Y
5 0.85R/W
6 0.5G/R
7 0.5B/W
8 0.85G/W
9 0.5W/G
10 0.5G/B
11 0.5W/L
12 1.25R/B
13 0.85R/L
Flasher Unit Action Test
1. Set the hazard switch to the ON position, and make sure the
hazard light gives 60 to 120 flashers for a minute.
2. Set the main switch to the ON position and move the turn signal
switch to the left. Make sure the left-hand light gives flashes.
Then move the turn signal switch to the right and make sure the
right-hand light gives flashes. Make sure the same actions as
above result.
3. If both the hazard switch and the turn signal switch and the turn
signal switch function but the above actions do not take place,
replace the flasher unit with new one.
(1) Flasher Unit
9-S20
ELECTRICAL SYSTEM
Approx. battery voltage
Approx. battery voltage
Lighting switch
Position light
Position light switch
Main switch (AC)
Turn signal light (R)
Turn signal light switch (R)
Ground
Turn signal light (L)
Turn signal light switch (L)
Hazard indicator lamp
Hazard switch
Battery voltage
Battery voltage (lighting)
9Y1210278ELS0021US0
KiSC issued 08, 2012 A
(EU)