Check Points Of Every 200 Hours - wsm Kubota L4100 Workshop Manual

L4100, WSM

[5] CHECK POINTS OF EVERY 200 HOURS

Toe-in
1. Park the tractor on flat ground.
2. Inflate the tires to the specified pressure.
3. Turn steering wheel so front wheels are in the straight ahead
position.
4. Lower the implement, lock the parking brake and stop the
engine.
5. Measure distance between tire beads at front of tire, hub height.
6. Measure distance between tire beads at rear of tire, hub height.
7. Front distance should be 2 to 8 mm (0.08 to 0.3 in.) less than
rear distance.
8. If the measurement is not with in the factory specifications,
adjust by changing the tie-rod length.
Toe-in ((B) - (A)) Factory specification
Adjusting
1. Detach the snap ring (3).
2. Loosen the tie-rod lock nut (1).
3. Turn the outer tube to adjust the tie-rod length until the proper
toe-in measurement is obtained.
4. Retighten the tie-rod lock nut (1).
5. Attach the snap ring (3).
Tightening torque Tie-rod lock nut
IMPORTANT
• A right and left tie-rod joint is adjusted to the same length.
(1) Tie-rod Lock Nut
(2) Tie-rod Joint
(3) Snap Ring
Checking Power Steering Oil Line
1. Check to see that all lines and hose clamps are tight and not
damaged.
2. If hose and clamps are found worn or damaged, replace or
repair them at once.
(1) Power Steering Pressure Hose
G-26
GENERAL
2 to 8 mm
0.08 to 0.32 in.
167 to 196 N·m
17.0 to 20.0 kgf·m
123 to 144 lbf·ft
(A) Wheel to Wheel Distance at front
(B) Wheel to Wheel Distance at rear
(C) Front
9Y1210278FAS0004US0
9Y1210278GEG0027US0
KiSC issued 08, 2012 A
(EU)