Front Wheels - wsm m9540 Workshop Manual

M9540Low Profile, WSM

(1) Front Wheels

Front tread width can be adjusted as shown with the standard
equipped tires.
To change the tread width
1. Remove the wheel rim and disc mounting bolts.
2. Change the position of the rim and disc (right and left) to the
desired position, and tighten the bolts.
3. Adjust the toe-in. (Refer to "[5] CHECK POINTS OF EVERY
200 HOURS" at "7. CHECK AND MAINTENANCE".)
IMPORTANT
• Always attach wheels as shown in the figure.
• If not attached as illustrated, transmission parts may be
damaged.
• When re-fitting or adjusting a wheel, tighten the bolts to the
following torques then recheck after driving the tractor 200
m (200 yards) and thereafter according to service interval.
(Refer to "[5] CHECK POINTS OF EVERY 50 HOURS" at
"7. CHECK AND MAINTENANCE".)
NOTE
• Wheels with beveled or tapered holes: use the tapered side
of lug nut.
Toe-in Factory spec.
Front wheel mounting
nut
Tightening
torque
Front disc mounting nut
Tire
Tread (a) 360/70R20
(1) Front Wheel Mounting Nut
(2) Front Disc Mounting Nut
(3) Front Wheel Disc
(4) Front Wheel Rim
LG-2
G GENERAL
2.0 to 8.0 mm
0.08 to 0.31 in.
259.9 to 304.0 N·m
M16 26.5 to 31.0 kgf·m
191.7 to 224.2 lbf·ft
259.9 to 304.0 N·m
M16 26.5 to 31.0 kgf·m
191.7 to 224.2 lbf·ft
A B
1574 mm 1634 mm
61.97 in. 64.33 in.
(a) Tread
W1039833
KiSC issued 09, 2008 A