wsm Kubota L4100 Workshop Manual page 186

L4100, WSM
24T Gear Shaft and 27T Gear
1. Remove the 24T gear shaft (1).
2. Remove the external snap ring (2) and 27T gear (3).
(1) 24T Gear Shaft
(2) External Snap Ring
Clutch Housing Bearing Holder
1. Remove clutch housing bearing holder (2) mounting screws.
2. Remove three interlock balls (4) after removing stopper screw
(1).
3. Pull out clutch housing bearing holder (2) by using two jack
screws M8 (3).
NOTE
• Take care not to fly out interlock balls (4) and springs (6)
when pull out bearing holder (2).
(When reassembling)
• Install three interlock balls (4) with a small amount of grease to
clutch housing bearing holder (2) after setting the shift forks and
shift rods to neutral position.
Clutch housing bearing
holder mounting screws
Tightening torque
Interlock ball stopper screw
(1) Interlock Ball Stopper Screw
(2) Clutch Housing Bearing Holder
(3) Jack Screw M8
3-S23
TRANSMISSION
(3) 27T Gear
9Y1210278TRS0019US0
48 to 55 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
35 to 44 N·m
3.5 to 4.5 kgf·m
26 to 32 lbf·ft
(4) Interlock Ball
(5) Shift Lock Ball
(6) Spring
9Y1210278TRS0064US0
KiSC issued 08, 2012 A
(EU)