wsm Kubota L4100 Workshop Manual page 177

L4100, WSM
Propeller Shaft
1. Slide propeller shaft front cover (1) and rear cover (2) after
removing screws (3).
2. Tap out spring pins (4), (5), slide couplings (6), (7), and then
remove propeller shaft together with propeller shaft covers.
(When reassembling)
• Apply grease to the splines of the propeller shaft.
• Tap in spring pin (4), (5) as shown in figure.
(1) Propeller Shaft Front Cover
(2) Propeller Shaft Rear Cover
(3) Screw
(4) Spring Pin
Separating Engine from Clutch Housing
1. Place the disassembling stand under the engine and clutch
housing case.
2. Remove the steering support plates connecting steering
support and rear bonnet support.
3. Remove the engine and clutch housing mounting screws and
nuts.
4. Separate the engine and clutch housing.
(When reassembling)
• Apply grease to the spline of clutch shaft.
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of the flywheel housing and clutch housing.
Engine and clutch housing
mounting screw and nut
Tightening torque
Engine and clutch housing
mounting stud bolt
3-S14
TRANSMISSION
(5) Spring Pin
(6) Coupling
(7) Coupling
9Y1210278ENS0024US0
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
40 to 49 N·m
4.0 to 5.0 kgf·m
29 to 36 lbf·ft
9Y1210278ENS0025US0
KiSC issued 08, 2012 A
(EU)