Top Clearance - wsm Kubota L4100 Workshop Manual

L4100, WSM

(3) Top Clearance

Top Clearance
1. Remove the cylinder head.
2. Move the piston and place a trip of fuse on the piston head at
three positions with grease.
3. Lower the piston, and install the cylinder head. (Use a new
cylinder head gasket and tighten with a specified tightening
torque.)
4. Turn the flywheel until the piston through the T.D.C..
5. Remove the cylinder head, and measure the thickness of the
fuses.
6. If the measurement is not within the factory specifications,
check the oil clearance between the crankpin and bearing and
between the piston pin and bushing.
NOTE
• After checking the top clearance, be sure to assemble the
cylinder head with a new cylinder head gasket.
Top clearance Factory specification
Tightening torque Cylinder head screws
(1) Piston
1-S11
ENGINE
0.55 to 0.70 mm
0.0217 to 0.0276 in.
93.2 to 98.0 N·m
9.50 to 10.0 kgf·m
68.8 to 72.3 lbf·ft
(2) Fuse
9Y1210278ENS0095US0
KiSC issued 08, 2012 A
(EU)