wsm Kubota L4100 Workshop Manual page 238

L4100, WSM
Axle
1. Remove the bearing with a special use puller set.
(Code No. 07916-09032)
2. Take out the bevel gear (2).
3. Take out the collar (1).
4. Take out the axle (3).
(When reassembling)
• Install the oil seal (5) of axle flange (4), nothing its direction as
shown in the figure below.
(1) Collar
(2) Bevel Gear
(3) Axle
Steering Cylinder
1. Remove the tie-rod joint (1) (right side).
2. Remove the cylinder set screw (3).
3. Remove the nipples (2) from steering cylinder.
4. Remove the internal snap ring (4).
5. Draw out the steering cylinder (5).
(When reassembling)
• Apply liquid lock (Three Bond 1324B or equivalent) to the tie-rod
joint.
Tie-rod joint and steering
Tightening torque
cylinder mounting screw
(1) Tie-rod Joint
(2) Nipple
(3) Cylinder Set Screw
6-S9
FRONT AXLE
(4) Axle Flange
(5) Oil Seal
9Y1210278FAS0028US0
167 to 196 N·m
17.0 to 20.0 kgf·m
123 to 144 lbf·ft
(4) Internal Snap Ring
(5) Steering Cylinder
9Y1210278FAS0016US0
KiSC issued 08, 2012 A
(EU)