Accessing Firmware Update; Using Firmware Update - NEC UNIVERGE SV9100 Programming Manual

ISSUE 2.0
6.1
6.2
SV9100 PC Programming Manual
Before Firmware Update can be used the system must meet the following
requirements:
1. Feature Activation
The Firmware Update feature must be registered through Feature
Activation. Refer to
details.
2. Hardware
The hardware prerequisite for Firmware Update is the USB drive. The
USB drive is used to store the Firmware Update file before the operation
is executed.

Accessing Firmware Update

When PCPro is connected to a chassis, access the Firmware Update dialog by
selecting the menu item

Using Firmware Update

Use the Firmware dialog to specify the parameters and perform a Firmware
Update.
To perform a firmware update:
1. Select a Firmware File.
Firmware Package File:
Select a Firmware package file provided by NEC. Updating a chassis with a faulty
Firmware page file could render the system unusable.
2. Schedule when the Firmware Update is to occur using the parameters in
the Schedule Update section.
Schedule:
Schedule when the Firmware update will occur. The changes of the
Firmware Update will only occur after the chassis is reset. Thus the
Firmware Update should be executed at a suitable time when the
chassis is not actively in use.
The time you specify should be relative to the time on the chassis, not
the local time of the PC.
NOTE
3. Press the Start button.
Section 5 Feature Activation on page B-16
Home > Maintenance > Upgrade
for
SW.
B-19