10.1 Adding A Time Frame; Figure 4-14 Standard View Night Mode Switching Adding Time Frame; Figure 4-15 Standard View Night Mode Switching Mode Colors - NEC UNIVERGE SV9100 Programming Manual

10.1 Adding a Time Frame

Figure 4-14 Standard View Night Mode Switching Adding Time Frame

Move the left mouse button
over the slider area until an up/
down arrow is displayed, While
holding down the left mouse
button, move the slider to the
desired position and release the
mouse button to set the time.
4-24
This section describes how to add a time frame to a schedule for night mode
switching.
Release the
mouse button
when finished.
Popup
indicating
duration and
Night Mode.
The Mode Selection dialog box
is displayed when the time
frame has been selected.
Select the desired mode from
the pull down selection menu.
To add a time frame in a Schedule:
1. Using the mouse on the Schedule Pattern bar, left click and drag from
the starting time toward the end time. A colored bar appears defining
this time frame. Keep the left mouse button pressed while dragging.
2. Release the left mouse button. A dialog then prompts for the Night
Mode associated with this time frame.
3. Select a Night Mode associated with this time frame.
The colored bar changes its color depending on the Night Mode
defined.
Each mode is assigned a different color. These colors are shown in
Figure 4-15 Standard View Night Mode Switching Mode Colors on page
4-25.
ISSUE 2.0
Standard View