Figure B-4 New Connection Wizard Dialog - NEC UNIVERGE SV9100 Programming Manual

ISSUE 2.0

Figure B-4 New Connection Wizard Dialog

SV9100 PC Programming Manual
Direct

A Direct Connection can be made via an available serial port on a PC.
Specify the PCs serial port and its transfer rate (bps). This speed
must match the KSU baud rate setting assigned in 10-21-02.
Modem

A Modem Connection can be made from an existing modem
connected to the PC. Specify the modem number to dial.
NOTE
2.2.2 Create SV9100 Dial Up Connection
When connecting an SV9100 via modem, a Dial Up Connection (PPP) must
be created. The following steps describe how to set up the Dial Up
Connection (PPP).
1. Click Start >Settings>Network
2. Select Setup a New Connection or Network.
To access the modem over K-CCIS, route the modem
❍
access service code to the target switch. Do not call a
station that is call forwarded to the service code. When
accessing the modem over K-CCIS, enter the service code
to be dialed in PCPro.
Note that PCPro follows the PCs dialing properties. If
❍
dialing a service code, you must turn off the dial 9 for
outside line and area code inclusion or PCPro will dial
these digits as well.
Connections.
B-5