NEC UNIVERGE SV9100 Programming Manual page 76

To setup a Trunk group complete the following:
1.
2.
3.
4.
5.
6.
7.
8.
4-34
Specify a Trunk Group (1~100) entry to modify.
Select the trunks that are members of the Trunk Group.
These settings are linked with 14-05-01.
Prioritize trunks by ordering them in preference.
These settings are linked with 14-05-02.
When a trunk is selected as part of the Trunk Group it automatically appears in
the priority list (the list to the bottom of the Trunk Group list). The priority of the
selected trunk can be modified using the following key combinations:
Shift + Up Arrow

Shift + Down Arrow

Shift + Page Up

Shift + Page Down

Shift + Home

Shift + End

To setup a Route Table entry:
This entry defines four destinations where the Route Table entry directs calls.
Calls can terminate on a Trunk Group or flow on to another entry in the Route
Table.
Destinations are prioritized 1~4 with 1 being the highest and 4 being the lowest.
These settings are linked with 14-06.
To assign the extensions and trunks that use the Route Table Entry, select a
Route Table (1~100) and a Night Mode.
Select the extensions that use the Route Table entry during the selected Night
Mode.
This applies to extensions using the Trunk Service Code to access trunks.
These settings are linked with 21-02.
Select the extensions, during this Night Mode, that use the Route Table entry
via the alternate Trunk Access Code.
This applies to extensions using the alternate Trunk Service Code to access
trunks. These settings are linked with 21-15.
Select the trunks, during this Night Mode, that use the Route Table entry.
These settings are linked with 21-03.
Increase priority by 1
Decrease priority by 1
Increase priority by one page
Decrease priority by one page
Make highest priority
Make lowest priority
ISSUE 2.0
Standard View