Radyne DMD50 Installation And Operation Manual page 121

DMD50 Universal Satellite Modem
SCT CLK SRC
DROP & INSERT (menu)
DROP MODE
MAP COPY
SAT CH TERRCH
ESC CHAN#1 (dB)
ESC CHAN#2 (dB)
RX SETUP (menu)
CIRCUIT ID
MN-DMD50 Revision 4
automatically corrects. If G.703 Interface is selected, this
selection cannot be changed.
{SCT, SCR}
Allows the user to select SCT Source.SCT is the internally
generated SCT clock. SCR is the Rx Satellite clock. SCR us used
for loop timing.
(Reference Section 3.13, "Drop and Insert Mapping" in this
manual)
{NONE, T1-D4, T1-ESF, PCM-30, PCM-30C, PCM-31,
PCM-31C, T1-D4-S, T1-ESF-S.}
Drop mode may only be changed from none when the drop and
insert specification is in use.
{SRC Map Dest Map}
Allows the user to copy drop and insert maps. Tx Act map is the
drop map currently being used by the modem. Source and
destination may be any of the following:
TX ACT, RX ACT, TX EDIT, RX EDIT,
USER 1 - USER 8, ROM 1 -ROM 8
{1-31 1-31}
The up/down arrow keys allow you to traverse the sat terr
pairings. The slot numbers may be edited using the keypad.
Allows the user to edit the Tx Edit map and specify the terrestrial
slots that will be dropped into the assigned satellite channels.
The satellite channels are fixed and the number of channels are
determined by the data rate. The terrestrial time slots available
are determined by the drop mode. When the user has finished
editing the Tx Edit map, it must be copied to the Tx Act map
before it will be used by the modem.
{-20 to +10 dB}
Allows user to select ESC Voice Channel Gain. Only
displayed when IDR NETWORK and VOICE Channel are
selected.
{-20 to +10 dB}
Allows user to select ESC Voice Channel Gain. Only
displayed when IDR NETWORK and VOICE Channel are
selected.
Provides entry of Rx Circuit Identifier. Circuits can be given up
to an 11 Character alphanumeric Identity such as DLINK1
User Interfaces
4–17