Radyne DMD50 Installation And Operation Manual page 123

DMD50 Universal Satellite Modem
BUFFER CLOCK POL
DROP & INSERT (menu)
INSERT MODE
T1/E1 FRAME SRC
TERR STREAMING
ESC CHAN#1 (dB)
ESC CHAN#2 (dB)
GENERAL (menu)
EXT FREQ (MHz)
REF FREQ SRC
REF FREQ (MHz)
MN-DMD50 Revision 4
Allows the user to edit the Tx Edit map and specify the terrestrial
slots that will be dropped into the assigned satellite channels.
The satellite channels are fixed and the number of channels are
determined by the data rate.
The terrestrial time slots available are determined by the drop
mode. When the user has finished editing the Tx Edit map, it
must be copied to the Tx Act map before it will be used by the
modem.
{NORMAL, INVERTED}
Allows the user to select the Buffer Clock Polarity for the Tx
Terrestrial Clock relative to the Tx Data. If G.703 Interface is
selected, this selection cannot be changed.
{NONE, T1-D4, T1-ESF, PCM-30, PCM-30C, PCM-31,
PCM-31C, T1-D4-S, T1-ESF-S.}
Allows the user to select any of the above.
{INTERNAL, EXTERNAL}
Selects the frame source for T1 or E1 framing.
{BYTE OUTPUT, PACKET OUTPUT} ASI only
Byte output = continuous
Packet output = burst
{-20 to +10 dB}
Allows user to select ESC Voice Channel Gain. Only
displayed when IDR NETWORK and VOICE Channel are
selected.
{-20 to +10 dB}
Allows user to select ESC Voice Channel Gain. Only
displayed when IDR NETWORK and VOICE Channel are
selected.
{Variable Through Data Rate}
Allows the user to select the external clock frequency in MHz.
{INTERNAL, EXTERNAL, HIGH STABILITY}
Allows the user to select the Frequency Reference Source. High
Stability is only displayed if the appropriate hardware is
detected.
Allows the user to select the reference clock frequency in MHz.
User Interfaces
4–19