Table of Contents
Advertisement
DMD50 Universal Satellite Modem
NOMINAL TX POWER
MINIMUM TX POWER
MAXIMUM TX POWER
TARGET Eb/No
MN-DMD50 Revision 4
NEARSIDE: Enables NEARSIDE Local AUPC function. In
the event the local demodulator losses lock due to signal loss, the
output power level will adjust itself to the nominal level. This
nominal power should be set to a level high enough to re-
establish communications regardless of rain fade.
{0 TO -25 dB}
This allows the user to set the nominal Transmit Power. The
nominal transmit power is the default output power level.
{0 to -25 dB}
This allows the user to set the minimum Transmit Power.
EFDATA AUPC: When configured for EFDATA AUPC the
minimum Transmit Power is the lowest power setting that will
be used when the local modem commands a decrease of the
Transmit Power from the Remote modem.
RADYNE: When configured for Radyne AUPC, the minimum
Transmit Power is the lowest power setting that will be used
when the remote modem commands a decrease of the Transmit
Power from the Local modem.
NEARSIDE: When configured for NEARSIDE AUPC the
minimum Transmit Power is the lowest power setting that will
be used by the local modem when the Eb/No increases above the
Eb/No target.
{0 to -25 dB}
This allows the user to set the maximum Transmit Power.
EF AUPC: When configured for EF AUPC, the maximum
Transmit Power is the highest power setting that the local
modem will use when the local modem commands an increase in
Transmit power from the Remote modem.
RADYNE: When configured for Radyne AUPC, the maximum
Transmit Power is the highest power setting that will be used
when the remote modem commands an increase of the Transmit
Power from the Local modem
NEARSIDE: When configured for NEARSIDE AUPC the
maximum Transmit Power is the highest power setting that will
be used by the local modem when the Eb/No decreases below
the Eb/No target.
{4.0 to 16 dB}
This allows the user to set the desired E
receiver.
RADYNE AUPC: When configured for Radyne AUPC, this
setting is compared against the remote E
the local modem to increase or decrease the local transmit
power.
User Interfaces
/N
for the local
b
o
/N
and commands to
b
o
4–9
Advertisement
Table of Contents
