Radyne DMD50 Installation And Operation Manual page 214

DMD50 Universal Satellite Modem
•
GUEST: Users are able to navigate most of the site, and view modem parameter settings.
•
OPER: Users can monitor and control modem parameter settings, and change their own
authentication passwords.
•
ADMIN: At this highest access right, users can monitor and control modem parameter
settings, change any user's name and authentication password, and modify IP network
settings. This setting has full access to the entire site.
•
NO GROUP: Assigning this will block all access from the site.
Listed in the table below are the factory default user names and corresponding default passwords
and settings:
USER ID
USER 1
USER 2
USER 3
Using the Front Panel display and arrow keys, scroll thru the System menu until the WEB sub
menu is displayed. Enter into the WEB menu and the following Sub menus will appear (order
may vary).
1. CONFIRMATION: When ENABLED, a change in the Web Interface will prompt a secondary
window to be displayed asking "Do you want to proceed". This will allow the user to either OK
the change or cancel the change. When this feature is DISABLED, the command will be
executed upon entering the command or parameter change. Commands pertaining to frequency
and data rates cannot be overridden. The Confirmation command is located under PASSWORD
SETUP/PREFERENCES.
2. USER 1: This will allow the operator to change the user name, assign the Access group,
authorized password for "USER 1". Upon entering the following fields will be displayed:
a. ACCESS GROUP: This will allow the assignment of "No Group", "ADMIN",
"OPER", or GUEST to USER 1.
b. AUTH PASSWORD: This will allow for the entry of the password for USER 1.
c. USER RESET: Using this command will allow the factory defaults (as listed in the
table above) to be restored to USER 1. This can be used in the event that USER 1 is
locked out due to password restriction.
3. USER 2: This has the same menu structure as USER 1.
4. USER 3: This has the same menu structure as USER 1.
Radyne's Web configuration allows for the support of 3 user profiles. These are configured
through the 'PASSWORD/SETUP ACCESS section in the Web Browser.
MN-DMD50 Revision 4
Access Authentication
Group
GUEST
OPER
ADMIN
All entries are case sensitive.
IMPORTANT
Web User
Password
guest guest
oper oper
admin admin
Web Browser Setup Guide
D–2