Radyne DMD50 Installation And Operation Manual page 141

DMD50 Universal Satellite Modem
HW/FW CONFIG (menu)
FIRMWARE REV
M&C REV
MAIN BOARD (menu)
Only the appropriate of the VCO adjustment screens listed below will be displayed.
These are protected fields, to prohibit accidental changes. To edit the field, the user must
depress all four of the direction arrow keys simultaneously.
INT VCO ADJUST
HI STAB VCO ADJUST
LARGEST HB GAP Used for factory test only.
SOFT RESET
IF BOARD (menu)
AGC/CTRL/VALUE {0% - 100%}
I OFFSET
Q OFFSET
IF RX LVL OFFSET Used for factory test only.
LB RX LVL OFFSET Used for factory test only.
POWER SOURCE
TERR INTFC BRD
CODEC BOARD (menu)
TPC FPGA IMAGE
RS FPGA IMAGE
TPC CODEC IMAGE Used for factory test only.
MN-DMD50 Revision 4
Displays the installed firmware revision.
Displays the installed Monitor and Control revision.
{0% - 100%}
Allows the user to adjust the internal frequency reference for
calibration. Only displayed of the system reference clock is
INTERNAL.
{0% - 100%}
Allows the user to adjust the internal frequency reference for
calibration. Only displayed if the system reference clock
source is HI STABILITY.
{Enter}
Indicates the Radyne part number for the IF Board Assembly.
Allows the user to adjust the internal frequency reference for
calibration. Only displayed if the system reference clock
source is HI STABILITY.
Used for factory test only.
Used for factory test only.
Used for factory test only.
Indicates the Radyne assembly number for the Terrestrial
Interface Assembly.
Indicates the Radyne part number for the Codec Board.
Used for factory test only.
Used for factory test only.
User Interfaces
4–37