Replacing The System Board - HP Integrity rx2620 User's & Service Manual

b. Lift up the processor module side of the system board and slide it free of the
PCI cage bay. See
Figure 66 Removing the System Board

Replacing the System Board

1. Remove the old system board.
2. Grasp the new system board by its edges and carefully align it in the server:
a. Angle the board to allow the PCI connector to slide into the PCI cage bay
area. See
Figure 67 Sliding the System Board into the Chassis
b. Align the system board keyholes with their standoffs on the chassis.
c. Slide the PCI connector posts on the system board into their slots on the
server chassis.
NOTE:
system board. See
60)"Removing the PCI Card Cage" (page
Figure 66.
Figure 67.
You must remove the PCI cage from the chassis to install the
"Removing and Replacing PCI Card Cage" (page
60).
73