Replacing Internal Components - HP ProLiant DL360 G7 Maintaining And Troubleshooting

No. Task
1 Power down server if the
part being replaced is
not hot-swappable.
2 Slide the server out of
the rack if required to
access the part being
replaced.
3 Replace the component:
• DL360G7 SRVR
146GB 10K SAS 2.5"
HDD
• DL360G7 SRVR
146GB 15K SAS 2.5"
HDD
• DL360G7 SRVR
300GB 10K SAS 2.5"
HDD
• DL360G7 SRVR PWR
SUP 460W HE
• DL360G7 SRVR AC
PWR SUP 750W
• DL360G7 SRVR DC
PWR SUP 1200W
4 Slide the server into the
rack (if slid out)
5 Connect the power
cable(s) to the power
supply (if disconnected)
6 Power up the server (if
powered down)

Replacing internal components

Use the checklist below to replace any of these internal server components:
November 2010
Reference
MSG: Power down the
server
MSG: Extend the server
from the rack
MSG: Remove the server
from the rack
MSG: Removal and
replacement procedures >
SAS and SATA hard drive
MSG: Removal and
replacement procedures >
Hard drive blank
MSG: Removal and
replacement procedures >
Hotplug power supply
MSG: Removal and
replacement procedures >
Power supply blank
UG: Installing the server
into the rack
UG: Powering up and
configuring the server
UG: Power up the server
Maintaining and Troubleshooting the HP ProLiant DL360 G7 Server
Comments on this document? infodev@avaya.com
Replacing internal components
Avaya recommendation
Determine whether the
replaceable component is hot-
swappable.
Check that the Cable
Management Arm (if present)
moves freely out of the way of
rear panel components.
Ensure that the replacement
power supply matches the
specifications of the defective
power supply.
Check that the Cable
Management Arm (if present)
moves freely out of the way of
rear panel components.
13