Table of Contents
Advertisement
User controls
•
User Button 1 & 2: Assign a menu function to the User 1 / User 2 button of the RCU. Available functions
are:
-
Freeze screen
-
Bank screen
-
Save to User
-
PIP/BIP
-
Aspect Ratio
-
Show message
-
User data
-
Network setup
-
Projector ID
-
Projector orientation
-
Custom RGBCYM
-
Multi-projection
-
Reset selective
Network setup
Configure the projector's Ethernet settings for network communications.
•
LAN Interface: Choose which RJ-45 port you connected the RJ-45 cable (either the RJ-45 input, or the
HDBaseT input).
•
MAC Address : Display the MAC address (read-only).
•
Network status: Displays the network connection status (read-only).
•
DHCP : Turn on DHCP to automatically acquire IP address, subnet mask, gateway, and DNS. If it is turned
off, manually enter the values for the network.
•
IP Address : Set the projector's IP address.
•
Subnet Mask : Set the projector's subnet mask.
•
Default Gateway : Set the projector's gateway.
•
DNS: Assign the projector's DNS
•
Apply : Apply the network settings.
•
Reset: Resets all network settings to the factory default values.
Control
For a more detailed description of the Control function, see "Controlling the projector over network", page 46.
Baud Rate
Select a serial port and baud rate. The available options include 1200, 2400, 4800, 9600, 14400, 19200,
38400, 57600, and 115200 (default).
Reset communication
Reset all communication settings to factory default values.
5.5 Controlling the projector over network
About controlling
This projector can be controlled remotely by a computer or other external devices through network connection.
It allows the user to control one or more projectors from a distant control center, such as powering the
projector on or off, and adjusting the image brightness or contrast. This projector is compatible with following
control devices and commands.
46
R5913459 /00
G100
Advertisement
Table of Contents
