Ksu Initialization - Tadiran Telecom Emerald ICE Quick Installation Manual

Section 3-Installation

KSU Initialization

1. Verify that the KSU power is OFF.
2. Verify that the jumper pins on JP7 are in the "Cold" position.
3. Power up the KSU and wait 10 seconds.
4. Power down the KSU and move the JP7 pins to the "Normal" position.
5. Power up the KSU again.
6. Verify that the telephones have been initialized. A date/time display will be visible on the
Deluxe Telephones. For a Standard telephone, a dial tone will be heard.
7. Enter the RMP programming mode and select RP, Remote Control, and perform a Soft-
ware Cold Start. It should be approximately 30 seconds before a display is visible on the
Deluxe Telephones or a Dial Tone is heard on a Standard Telephone.
8. When a display is visible on the Deluxe Telephones or a Dial Tone is heard on a Standard
Telephone, power down the KSU, wait 15 seconds, and then power up the KSU again.
Page 3-14