Table of Contents
Advertisement
Step A: Assembly of the Wing
Wrap supplied
clear tape around
the center joint.
(Step A-3)
Carefully remove the contents from the box. It' s recommended
that you charge the transmitter and receiver batteries for 16 hours,
as per the instruction included with the radio.
Step A-1
To assemble the wing, first remove the wings from their protective
plastic bag. Remove the pieces of tape holding each aileron in
place. The hinges of the ailerons have already been glued in place.
Flex the ailerons back and forth to make sure movement is free.
Step A-2
Locate the aluminum tube and carefully slide it into one of the
holes in either of the wing halves. The fit may be snug, so use a
gentle twisting motion. One wing has a short metal pin projecting
from the area near the trailing edge. This is used to key the wings
together. Slide the other wing half onto the aluminum tube until
the wing is joined. Be sure the metal pin fits into the hole in the
other wing half.
Remove shipping tape.
(Step A-1)
Slide the metal rod in one panel.
Then, attach the other panel.
(Step A-2)
Step A-3
Locate the clear tape and apply to the center joint of the wing,
around the top and bottom.
Step A-4
The aileron servo lead has been tied around the aileron linkages
to keep them from moving during shipment. There is a tag identi-
fying the lead as the aileron lead. Untie the lead so it is free and
the aileron linkages are free. One of the aileron linkages has
already been attached. A small piece of tubing (clevis keeper) is
used to hold the clevis closed. This is done to prevent accidental
opening of the clevis in flight.
Connect the other aileron linkage being sure the clevis is securely
snapped. Position the small piece of tubing to hold the clevis closed.
Congratulations! You have just completed assembly of the wing.
Bottom view of wing
Attach clevis.
(Step A-4)
5
Advertisement
Table of Contents
