Wing Assembly - Hangar 9 Alpha 40 ARF Assembly Manual

Wing Assembly

Required Parts
Wing panel (left and right) Aluminum wing tube
Clear tape
note: The following covers the assembly of the wing
without the use of glue. The wing, when joined in this
method, is very strong and does not need to be glued
together. You will want to purchase additional clear tape
if you plan on breaking the wing down into two pieces
for transportation purposes.

Step 1
Locate the items necessary to join the left and
right wing panels.
40

Step 2
Slide the wing tube into the wing panel as shown. The wing
tube will only slide in halfway, so do not force it in any
further than it will slide easily.

Step 3
Slide the remaining wing panel onto the wing tube.

Step 4
As you slide the wing panels together, make sure the
aluminum pin at the back (trailing edge) of the wing slides
into the hole of the receiving wing panel. Slide the two wing
panels tightly together so there is no gap between the two.

Step 5
Use the supplied clear tape to secure the joint between the
two wing panels. Make sure to apply the tape to both the top
and bottom of the joint.
Hangar 9 Alpha 40 ARF Assembly Manual