Acknowledge The Emergency State; Exit The Emergency State; Distribute Live Speech - Bosch Plena Operating Manual

92 en | Operation
At the moment the emergency state is entered, a beeper starts and the EMG status output
contact are closed. See section Exit the emergency state, page 92 for information about
exiting the emergency state.
7.4.2

Acknowledge the emergency state

The beeper can be switched off by acknowledging the emergency state with the EMG Ack
button on the voice alarm controller or the remote controls. The beeper can also be switched
off by acknowledging the emergency state with the Emergency Acknowledge button on the
fireman's panel.
Figure 7.9: EMG Ack button
7.4.3

Exit the emergency state

Exit (reset) the emergency state by pushing the EMG Reset button on the voice alarm
controller or the remote controls. The emergency state can also be reset with the Emergency
Reset button on the fireman's panel. In order to reset the emergency state, it first must be
acknowledged (see section Acknowledge the emergency state, page 92).
Figure 7.10: EMG Reset button
7.4.4

Distribute live speech

Proceed as follows to distribute live speech:
1.
2.
2013.07 | V2.0 |
Fault EMG
Ack
Zone select
Reset
Zone1
Fault EMG
Ack
Zone select
Reset
Zone1
Select zones (see section Select zones, page 93).
Make announcement (see section Make the announcement, page 94).
Installation and Operation manual
Zone2
Zone2
Plena
Bosch Security Systems B.V.