Reset The Fault State - Bosch Plena Operating Manual

Plena
7.5.2

Reset the fault state

Reset the fault state by pushing the Fault Reset button on the front of the voice alarm
controller or the remote controls. The fault state can also be reset by pushing the Fault Reset
button on the fireman's panel. In order to reset the fault state, it first must be acknowledged
(see section Acknowledge the fault state, page 96).
When the Fault Reset button is pushed, the fault indicators are switched off and the status of
the system is checked.
–
–
Figure 7.20: Fault reset button
Bosch Security Systems B.V.
If the fault is not resolved, the fault indicators are switched on again. The beeper remains
off. It is only switched on if a new fault occurs or if the resolved fault occurs again.
If the fault is resolved, the fault indicators remain off.
Fault EMG
Ack
Zone select
Reset
Zone1
Installation and Operation manual
Zone2
Operation | en 97
2013.07 | V2.0 |