Emergency State; Enter The Emergency State - Bosch Plena Operating Manual

Plena
Indicator
Yellow
Green
Red
Table 7.1: Call station status indicators
7.4

Emergency state

Emergency calls can only be distributed when the system is in the emergency state. See
section Enter the emergency state, page 91 for information about entering the emergency
state. In the emergency state, it is possible to distribute the following emergency calls:
–
Notice!
It is not possible to distribute chimes or speech with the call station when the system is in
the emergency state, because the call station is disabled automatically at the moment that
the system enters the emergency state.
–
–
Notice!
It is also possible to distribute emergency calls using emergency trigger inputs. When an
emergency trigger input is activated, the system automatically enters the emergency state
and takes the action that is programmed with the configuration software.
Notice!
See the Configuration Software Manual for more information about the configuration
software.
7.4.1

Enter the emergency state

To enter the emergency state, push the emergency button on the front of the voice alarm
controller or the remote controls. The red LED that is integrated in the switch lights. The
emergency state can also be entered by pushing the Emergency button on the fireman's panel.
Figure 7.8: Emergency button
Bosch Security Systems B.V.
Live speech with the emergency microphone of the voice alarm controller or remote
controls (see section Distribute live speech, page 92).
The default alert message (see section Distribute the alert message, page 94).
The default alarm message (see section Distribute the alarm message, page 96).
Alert message
Alarm message
Indicator test
EMG mic
Installation and Operation manual
Position
Left
Center
Right
All call
Operation | en
Description
System fault
Talk (green). Busy (Yellow
flashing).
System in emergency state,
call station disabled
2013.07 | V2.0 |
91