Setting The Wireless Remote Controller - Daikin FCQ35B7V1 Service Manual

ESIE05-04
1.3

Setting the Wireless Remote Controller

Introduction To set the wireless remote controller, you have to set the address for:
Setting the address The address for the receiver of the wireless remote controller is factory set to 1. To change this setting,
for the receiver proceed as follows:
Step
1
2
3
4
5
6
Part 4 – Commissioning and Test Run
The receiver of the wireless remote controller
The wireless remote controller.
Action
Turn OFF the power.
Remove the sealing pad on the top of the receiver.
Small opening
Set the wireless address switch (SS2) according to the table below. You can find the wire-
less address switch attached on the PCB of the receiver and it is visible through the small
opening on the back of the receiver.
Unit No.
SS2
If you use a wired and a wireless remote controller for one indoor unit, proceed as fol-
lows:
1. Set the wired remote controller to MAIN: On the remote controller.
2. Set the wireless remote controller to SUB: On the receiver with the MAIN/SUB switch
(SS1).
MAIN/SUB
SS1
Seal off the opening of the address switch and the MAIN/SUB switch with the attached
sealing pad.
Sealing pad
Small opening
Make sure to also change the address on the remote controller.
Sealing pad
Receiver
No. 1 No. 2
SUB
MAIN
S
M
Receiver
Pre-Test Run Checks
S
M
3
2
1
No. 3
S
M
S
M
3
2
1
1
3
4
5
4–5