Address Setting For Wireless Remote Controller; Setting For Signal Receiver Pcb - Daikin VRV X RXQ6-48ANR Series Service Manual

Address Setting for Wireless Remote Controller

4. Address Setting for Wireless Remote Controller
If setting multiple wireless remote controllers to operate in one room, perform address setting
for the receiver and the wireless remote controller.
(This includes an individual remote controller control using the group operation.)
(For the wiring for the group operation, please refer to the installation manual attached to the
indoor unit and technical guide.)
4.1

Setting for Signal Receiver PCB

The address for the receiver is set to 1 at the factory. To change the setting, set the wireless
address switch (SS2) on the signal receiver PCB according to the table below.
44
Unit No. No. 1
Wireless address
switch (SS2)
The side painted black indicates
the switch knob position.
Transmitter assembly
S
M
2 3
1
SS1
SS2
No. 2 No. 3
SiME341909EA
Part 3 Remote Controller