ESIE05-04
Step
3
Disconnect wires and
connectors from PCB.
4
Arrange wire harness to
avoid interference with
next process.
5
To dismount drain pan
blocking plate, remove
each two mounting
screws located at four
corners.
Part 5 – Disassembly and Maintenance
Procedure
Disassembly and Maintenance
Points
Caution:
This work should be done by two
personnel.
If drain water remain in the pan, it
may drop and stain on the floor.
Make sure to check if no drain
water remain in the pan, or cover
the floor with vinyl sheet before
disassembling work.
1
3
5
5
5–103