Automatically Charging; Power On/Pause/Power Off; Get Power Supply And Power On - ECOVACS ECO D62 Instruction Manual

Automatically charging

5. POWER ON/PAUSE/POWER OFF

Get power supply and power on

• When it finishes cleaning or there is low battery, it would seek char-
ger in same route as automatic cleaning.To make it easy for robot to
search for charging block, you need to put the block back to the wall
and make sure there is no obstacle within 1.5 meters ahead of the
infrared receiver. Check carefully whether there is strong reflector
in front of the charger, such as ground glass, smooth ceramic vase
and so on.
• It takes time for robot to seek the charger. The reserve time differs
from the ground situation.
• Robot can return to the charger if the ground situation is not too
complicated. Under extreme circumstance, such as, huge house
and complex layout would probably bring difficulty for robot to seek
for charger. In such case, you should help to put the robot back to
charge.
• Take care of the first automatic charging, if you find that the robot
keeps turning in the certain area after trying several times to seek
back, you can help to place it on the charger and look through the
charging.
• Under mode, main brush will stop working and robot cannot do
the cleaning.
• Robot shall stay at the charger when it finishes charging and it
transfer to small currency to charge until you start operating. If you
have set appointment timing cleaning, it would go out of the charger
to do cleaning when it comes to appointment time.
D62
• Turn on the power switch
• Press key
D66
• Turn on the power switch
• Press MODE key to choose cleaning mode. Then press
the robot will work under selected cleaning mode. Information of
cleaning mode, please refer to MODE SELECTION section.
on the bottom firstly.
to start Deebot.
on the bottom firstly.
ENG
Enjoy smarter life
ENG - 125