Robot Charging; Automatically Charging - ECOVACS ECO D77 Instruction Manual

Robot Charging

Automatically charging

• Before charging, please turn ON the robot by pressing
button . (0 OFF 1 ON.)
• Before using for the first time, charge the Robot for a mini-
mum of 12 hours. Run the Robot until it wants to seek the Char-
ger Dock to recharge. Do this for 2 or 3 times to achieve the best
performance for the battery. When charging, the indicator flashes;
when battery is fully charged, the chargeing indicator turn off.
• Robot should be charged under normal temperature. A war-
mer or cooler room may require a longer charging time, or even
break the batteries.
Tips:
► While the Robot is charging in the Charger Dock, the Char-
ging indicator P16 will blink. Once the Robot's battery is fully char-
ged, the charging indicator P16 turn off.
► Make sure the robot is turned ON when charging.
► Please keep the robot stay in charging dock when it is fully
charged to achieve best cleaning efficiency. When it finished char-
ging, it will automatically switch to a lower current.
► If Robot has NOT been used for a long time, please firstly
charge its battery three times repeatedly for three minutes. Then
charge the robot for 3-5 hours for next use.
• When it finishes cleaning or there is low battery, it would seek char-
ger in same route as automatic cleaning.To make it easy for robot to
search for charging block, you need to put the block back to the wall
and make sure there is no obstacle within 1.5 meters ahead of the
infrared receiver. Check carefully whether there is strong reflector
in front of the charger, such as ground glass, smooth ceramic vase
and so on.
• It takes time for robot to seek the charger. The reserve time differs
from the ground situation.
• Robot can return to the charger if the ground situation is not too
complicated. Under extreme circumstance, such as, huge house
and complex layout would probably bring difficulty for robot to seek
for charger. In such case, you should help to put the robot back to
charge.
• Take care of the first automatic charging, if you find that the robot
keeps turning in the certain area after trying several times to seek
back, you can help to place it on the charger and look through the
charging.
• Under mode, main brush will stop working and robot cannot do
the cleaning.
• Robot shall stay at the charger when it finishes charging and it
transfer to small currency to charge until you start operating. If you
have set appointment timing cleaning, it would go out of the charger
to do cleaning when it comes to appointment time.
ENG
Live Smart. Enjoy Life.
ENG - 127