Automatically Charging - ECOVACS Deepoo ECO D58 Instruction Manual

AUTOMATICALLY CHARGING

ENG - 114
• When it finishes cleaning or there is low battery, it would seek
charger in same route as automatic cleaning. To make it easy
for robot to search for charging block, you need to put the block
back to the wall and make sure there is no obstacle within
1.5 meters ahead of the infrared receiver. Check carefully whe-
ther there is strong reflector in front of the charger,
such as ground glass, smooth ceramic vase and so on.
• It takes time for robot to seek for the charging block. The
reserve time differs from the ground situation. Maximum reserve
time is 10 minutes.
Robot can return to the charger if the ground situation is not too
complicated. Under extreme circumstance, such as, huge house
and complex layout would probably bring difficulty for robot to
seek for charger. In such case, you should help to put the robot
back to charge.
• Take care of the first automatic charging, if you find that
the robot keeps turning in the certain area after trying several
times to seek back, you can help to place it on the charger
and look through the charging.
• Under mode, main brush will stop working and robot can-
not do the cleaning.
• Robot shall stay at the charger when it finishes charging
and it transfer to small currency to charge until you start opera-
ting. If you have set appointment timing cleaning, it would go out
of the charger to do cleaning when it comes to appointment time.