Common Failure - ECOVACS ECO D62 Instruction Manual

Icon Cause of failure
1) Dust box is not fixed
into host.
2) Dust box is not fixed
properly.
1) Main brush or driving
wheel is tangled by
hair or cloth.
2) Side brush is
blocked.
Driving wheel NOT on
floor

13. COMMON FAILURE

Problem
1) Make sure the power switch on the bottom of the robot is turned ON so
2) The silver charging contacts on the robot are not properly connected with
3) While the Robot is in the Charging Dock, the battery will continue to be
Robot fails to
charge.
4) The battery in the Robot needs to be properly activated. Following is the
1) With a dry cloth, clean the three sensors on the bottom of the unit to
The robot 2) Driving wheels are entangled by obstacles. Please remove them all.
keeps moving 3) The bumper on the front of the unit is not functioning properly. To see if
backwards, left
or right while
power is on.
4) If the unit does not respond, Service of the unit will be required.
ENG - 140
1) Put dust box back
2) Re-install dust box
1) Clean main brush
2) Clean side brush
Put the robot back on
charger to charge.
the battery will be charged. The Indicator Light Flashes when the battery
is charging and is NOT an indication of the battery being charged.
the charging contacts on the Charger Dock.
charged at a low rate so as not to hurt the battery. If the Charging Dock
is unplugged, and the Robot is in the Charging Dock and the Robot's
switch is NOT turned OFF, then the Robot will consume power from the
battery.
proper method for activating the battery when first received: charge the
battery for 3 minutes and remove from Charging Dock. Repeat this 3
times. Then charge the robot for 5 hours. Should there still be a problem
with the Battery and its charge, please contact our Service Center for
more information.
remove dust.
this is the cause, place your hand in front of the bumper and gently hit
you're your hand; the cleaner should change direction. Repeat this on the
two sides.
Solution
D62
into host.
and press it down at
the same time.
and put it back.
Must change it
if necessary.
Solution
Instruction
This function can prevent
danger of child or pet
lifting the robot when it is
operating.