Current Time Setting - ECOVACS ECO D62 Instruction Manual

1) After power is on, keep press
LCD is light and the number with time setting is flashing.
2) Set hour and minute via
decrease one hour and minute for . For confirm setting and continue press
3) When you finish setting first time, press
Tips:
• Selection scope: hour is between 0 and 23, minute is between 0 - 59
• Under normal circumstance, time display on LCD shows current time.
For example:
Set current time as 12:07 pm,time display on LCD should be:

Current time setting

After setting the programmed cleaning time, it will automatically go to the current time setting.
The disappears, the
Set hour and minute
decrease one hour and minute for , and then press
Tips:
• Selection scope: hour is between 0 and 23, minute is between 0 - 59
• Under normal circumstance, time display on LCD shows current time.
For example:
Set current time as 12:07 pm,time display on LCD should
be:
Note:
When the Robot is turned OFF, Robot will NOT start working on the scheduled time. If you have
already programmed the scheduled cleaning time, you must turn the Robot ON and keep it in
ready mode so when it is time to clean, it will automatically leave the Charger Dock to clean.
for around 3 seconds then start first time setting.
and , each time press
again, and then go to second time setting.
get appers and the number will blink on the LCD.
and , each time press
will increase one hour or minute. While
will incrase on hour or minute. While
to confirm.
ENG
Enjoy smarter life
on
.
ENG - 129