ECOVACS ECO D62 Instruction Manual page 145

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 112
Wall unit to keep the Robotic vacuum
cleaner away from the wires.
21) How can I stop the robot from operating
on appointment time since I will be
away from home for sometime?
Answer: You can cancel appointment
cleaning (page 128).
22) How can I transfer my robot?
Answer: You can lift it up with both
your hands and lay on the ground
quickly, dust and garbage in dust box
will come out if it is not place back
in time.
23) How to use robot most effectively?
Answer: Put the robot and charger
in the same room, because it would
shorten seeking time and it can extend
the working time. If you need robot to
clean every room of house, you should
put the charger in the middle of house
for the convenience of return back
to charge.
24) What should do if robot sucked liquid?
Answer:
a. Turn off the power and take out dust
box, then empty it and wipe it dry.
b. Draw out the sponge filter and wipe
it dry.
c. Take out main brush and clean it,
then use day cloth to wipe the brush
and its interior. Wait until the brush
is day and place it back.
d. Let the product dry by itself for at
least 12 hours (make sure circuit
board is dry and then get power on)
If the procedures above still do not
make it work, please contact our
after-sales service.
25) Dust box is emptied but the indicator
on LCD still inform you to empty the
dust box?
Answer:When this happens, turn OFF the
Robot and check that the Dust Box has
been properly placed in the unit. Clean
dust on dust sensor. Turn the unit ON and
the indicator alarm should not show
a problem.
26) How to clean the LCD screen?
Answer: Please clean the screen with
soft dry cloth to wipe away the
fingerprint or other dirt.
27) Why the side brush is easy to destroy?
Answer: If the brush runs over a power
cord, the filaments can become wrapped
around the cord and may become
distorted.
28) The Robot vacuum cleaner's working
time has shortened and the cleaner
cannot be charged?
Answer:
You can reactive Deebot battery as the
following:
Take Deebot out of the charging station
after charging for around 3 minutes and
recharge after 1 minute. Do the cycle for 3
time and charge Deebot continuously for
12 hours.
After doing the above, if your robot
still can not work normally, please
contact the service department for
more information.
ENG
Enjoy smarter life
ENG - 145

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eco d66

Table of Contents