Alarm Function - ECOVACS ECO D62 Instruction Manual

Remove the screw from the
Battery cover, remove the
Battery cover.
Note: Repeat the steps above to replace the second Battery pack.

12. ALARM FUNCTION

Note
The robot will stop working under following circumstance; there will be alarm and tip sound at
the same time. What's more, LCD will have red light flashing. Please notice the tip on LCD.
Icon Cause of failure
1) There is too much
dust in dust box.
2) There is too much
dust on dust sensor.
1) Dust box is not fixed
into host.
2) Dust box is not fixed
properly.
1) Main brush or driving
wheel is tangled by
hair or cloth.
2) Side brush is
blocked.
Driving wheel NOT on
floor
Low battery.
Disconnect the old Battery
by removing the Battery
connector from its socket.
Solution
D66
1) Clean dust box.
2) Clean dust on
dust sensor.
1) Put dust box back
into host.
2) Re-install dust box
and press it down at
the same time.
1) Clean main brush
2) Clean side brush
and put it back.
Must change it
if necessary.
Put the robot back on
charger to charge.
Put the robot back ma-
nually.
Enjoy smarter life
Connect the new Battery to
the socket. Carefully lower
the Battery pack into the
Battery compartment. Refit
the Battery cover and tigh-
ten Battery cover screw.
Instruction
In order to extend use
life, Robot will alarm
even though there is not
much dust inside after
several cycles cleaning.
This function can prevent
danger of child or pet
lifting the robot when it is
operating.
ENG - 139
ENG