Set Frequency And Cancel Timing; Remote Control; Battery Placement; Use Remote Control - ECOVACS ECO D62 Instruction Manual

Set Frequency and Cancel Timing

Tips:
►No matter in which cleaning mode the robot operated last time, it will work in the Auto Mode in
the next scheduled time.
►If robot is working under „edge mode" or „spot mode", the robot will not work according to
scheduled time when that time comes.
You can set appointment cleaning frequency via press
to clean on appointment time for one time
to clean on appointment time everyday here after.
to cancel appointment timing, robot only works
upon your manual operation

8. REMOTE CONTROL

Battery placement

Use remote control

Tips:
►It applies two units of alkaline batteries AAA.
►Please note the positive and negative when place the battery
►Change the battery when you notice it is in low battery and make sure you use the same kind
of battery as mixture is forbidden.
►Take out the battery if you do not use remote control for long time to avoid electrolyte from
leaking which may cause failure.
►Do not put the remote control in extremely hot or humid surroundings.
►Never expose the signal transmitter under sunshine or lighting equipment, or else it would
cause failure.
►The deposal of used battery should conform with local environmen-
tal legislation.
You can control the robot via remote control.
• Drive robot to appointed area via using direction control button.
ENG - 130
direction
control
key