ECOVACS ECO D62 Instruction Manual page 141

1) 1 the battery is completely out of charge and will NOT run.
The robot fails
2) 2 the battery is LOW on Charge and will NOT do the desired cleaning
to run under
BUT will automatically seek the Charging Dock to return to and charge
set mode.
the battery.
Dust box is
1) When this happens, turn OFF the Robot and check that the Dust Box
emptied but
has been properly placed in the unit. Turn the unit ON and the indicator
the indicator on
alarm should not show a problem.
LCD still inform
2) Clean dust on dust senzor
you to empty
the dust box.
Turn the power ON and place unit on floor. The Robotic vacuum cleaner will
get itself into trouble at times and will need your help. Because of some tight
spots between furniture, walls and other items, the cleaner may keep chan-
ging direction by going in a circle. In this case you will have to retrieve it and
Robotic vacu-
place it in the open again.
um cleaner is
It could also become tangled in:
in trouble.
A) a power cord.
B) curtains.
C) carpet fringe.
D) newspapers/ magazines.
Why does the
Robotic va-
cuum cleaner
The Robotic vacuum cleaner will change its cleaning pattern according to the
slow down
concentration of the debris it detects. It will then go back to the original clea-
or move bac-
ning made that was programmed.
kwards someti-
mes when it is
cleaning?
Robot is able to detect most stairs within a 8 cm height difference from the
Robot fails floor. However, its performance will weaken when it is on a hard floor surface
to detect the and the step is of a high reflective surface. To correct the problem, you can
stairs. put Virtual Wall unit in front of the stairs or the magnetic strip before the stairs
to prevent the unit from falling down the stairs.
1) First check that the battery has enough charge to run in the selected
The side brush
mode.
of the robot is
2) Check whether the side brush is entangled with hairs, threads or the like.
not working.
Please remove debris from the filaments.
1) First check that the battery has enough charge to run in the selected
mode.
2) Check the Agitator Brush for any hairs or threads entangled that will keep
the brush from rotating.
The main brush
3) Remove the bottom plate and Agitator and check for debris in the area
is not working?
where the Agitator rotates. Clear of any debris and obstructions and
replace the agitator, making sure it is free to rotate.
4) The brush will get entangled if it is working on a carpet whose threads
are longer than 2cm.
ENG
Enjoy smarter life
ENG - 141